Chris King 135mm x 10mm Rear ISO Thru Axle, with Adjusting Clamp, and DT Swiss RWS 10mm Thru Bolt.

Chris King Mfg# PHB559,135mm x 10mm thru axle, fits Chris King ISO rear hubs (non-boost, and not compatible with their 150mm, 157mm, or single speed hubs)

The DT Swiss RWS 10mm thru bolt has an aluminum lever handle (not their previous version with the plastic handle).

Note that the adjusting clamp included is the Chris King "low profile" version (Mfg# PHB702), which works, but its small hex bolt is less accessible when a disk rotor is installed. (If you find you want the convenience of the "high profile" adjusting clamp, the Mfg# is PHB708.)